Home / How-to / Build Slackware Kernel – By LinuxHint.com

Build Slackware Kernel – By LinuxHint.com

Linux Kernel • slackware

Compiling Slackware Kernel

Building Slackware’s kernel

Sometimes the operating system does not support our hardware by default, or we just want to remove support of hardware we don´t need. Lately Linux users forgot about this post installation task which once was very usual.

After learning to install Slackware now we’ll see how to build Slackware’s kernel.

First of all lets download the kernel by running:

wget –no-check-certificate http://kernel.org/pub/linux/kernel/v2.6/
linux-2.6.38.2.tar.bz2

Then we extract in the /usr/src directory:

tar -C /usr/src -jxvf linux-2.6.38.2.tar.bz2

We create a symbolic link to our new kernel sources:

ln -s linux-2.6.38.2 linux

Now we’ll download the headers:

wget http://slackware.mirrors.tds.net/pub/slackware/slackware-14.2/source/k/config-x86/
config-generic-smp-4.4.14-smp

cp config-generic-smp-4.4.14-smp /usr/src/linux/.config

To start selecting and removing modules run:

cd linux
make menuconfig

You can alternatively to “make menuconfig” run “make oldconfig” or “make xconfig”.

 

When the grey and blue screen starts (if you have chosen menuconfig instead of xconfig and oldconfig) its time to pay special attention to every move. A wrong choice in this step may result in a kernel crash.

Start checking all options and suboptions carefully, you can uncheck support for hardware you are sure you aren’t using, for example, if you aren’t using a Lenovo computer, you can uncheck the options for such devices, you can disable processors of a different type from the one you are using, wireless cards you don’t need but the most important thing is to add support for hardware you need. Usually that’s what people build kernels for.

Carefully we’ll review all options, with the space key we’ll select modules to load by default, by pressing M we’ll load them as disabled modules.
Check the filesystems, ram,device drivers, firmware, processor, networking, all options and don’t try to save time in this step.
Once you finished, go to SAVE and press ENTER. Then press OK and twice on EXIT.

    

Now lets compile the modules by running the following command (this process may last a long time):

make bzImage modules

 

In order to install the modules run

make modules install

 

We can prevent the lba32 warning by adding it to Lilo, we’ll do it later.
Now run:

cp arch/x86/boot/bzImage /boot/vmlinuz-custom-2.6.38.2

Now lets run  the final commands to continue later with lilo:

cp .config /boot/config-custom-2.6.38.2
cd /boot
rm System.map
ln -s System.map-custom-2.6.38.2 System.map

Now lets fix lilo by running:

nano /etc/lilo.conf

By pressing CTRL+W we’ll search the word “override” and we’ll see “change rules” with the option “reset” below, lets add “lba32” to prevent the Lilo’s warning we saw before

After that go the bottom of the screen and add the new kernel.

Once the changes were carefully done, press CTRL+X and then Y to exit lilo, and run lilo:

lilo

We can see it added a new kernel and this time didn’t return errors or warnings. Now restart your device and when booting select the new kernel:

Try your new kernel, if it boots properly, then edit lilo again changing the default kernel for the new one.

Facebook Comments

About

Check Also

Steam on Linux

Steam on Linux by Linux Hint (Video)

Facebook Comments